Z34 370z high tensile offset steering rack conversion extenders
Z34 370z high tensile offset steering rack conversion extenders
Z34 370z high tensile offset steering rack conversion extenders


Z34 370z high tensile offset steering rack conversion extenders

Sale price$159.00 AUD
In stock

What is a Backorder?

Q: What is backorder?

When a product is on backorder, it means that we have sold out and we are opening a back order due to popular demand. This is essentially a queue, when new stock arrives from production, we’ll send your order.

Q: Will items in my order that are in stock be shipped out first?

We will send your order altogether once your backorder item is ready! You may wish to place separate orders if you want an item before the other is due back in stock.
Pickup available at Sunshine West, VIC 3020 Usually ready in 2 hours

Z34 370z high tensile offset steering rack conversion extenders

Sunshine West, VIC 3020

Pickup available, usually ready in 2 hours

Unit 11/94 Boundary Road
Sunshine West VIC 3020


Free Shipping on orders over $250

Checking Dispatch Times...

Product enquiry

The GKTECH high tensile offset steering rack conversion extenders offer 3 primary benefits; offset rack spacer moving the rack forward to eliminate steering bind on high lock setups, unique to our design these convert the tie rod thread from the uncommon M18 to a much more common M16 and they offer more steering rack travel which in turn gives more steering lock. Offset rack spacers are a great alternative to moving the steering rack forward. Relocating the steering rack is expensive and in some cases just not possible. This product converts what are normally an 18mm inner tie rod thread to a 16mm inner tie rod thread which is a much more common size (such as S-chassis, Skylines etc.) In addition to converting to a more common tie rod thread this rack spacer set offers a grand total of 16mm of rack travel equating to around 12-15 degrees of extra lock without compromising on the amount of thread left in the steering rack.


- DIY installation
- CNC machined high tensile zinc coated 4130 steel


How does this steering rack spacer work?
The steering rack spacer screws between the steering rack and your inner tie rod. It allows the steering rack to travel an extra (16mm). That extra 16mm of rack travel gives approximately 12-15 degrees more lock (assuming you have adequate clearance elsewhere)

I've installed the rack spacer and I've got a heap of toe in, what happened?
After you have centred your rack (this is CRUCIAL) you will need a wheel alignment. You may also need need to either trim your inner tie rods down to counteract the length that you've just put into the length of the rack or go to an inner with more adjustment. Whether you need to trim the tie rods down depends on your setup.Do NOT trim too much off or else you'll need to get a new tie rod and only trim down once you've centered the rack. Note that the LH side has a larger spacer so it will need the most attention.


NOTE: will not work with OEM tie rods. This product is designed to convert your car to use M16 (on the rack side) tie rods as used on Nissan Silvias, Skylines, Z33 350z etc with a 14mm outer like the ones we sell.


Z34 370Z


Install Videos

Customer Reviews

Based on 2 reviews
Matthew Guerra
Havnt used them yet

Haven’t tried them yet still putting in a new motor but after the first drift event I’ll give u my thoughts afterwards

Peter Benincasa
What needs to be said??!

As always, shipping was prompt, product is great, fitment is drama free. No more waiting on goofy a$$ sized Infiniti tie rods now. Used on G37 with their angle kit.