The GKTECH Polyurethane rear knuckle bush replacements are designed to replace the OEM upper arm bushes on the knuckle side. These are required when removing the ball joint from a HICAS equipped knuckle however can also be used to replace the OEM rubber bushes for camber and traction arms also. These are designed to be used on the knuckle side only and can not be used elsewhere.
NOTE: Sold as a pair (ie. 2pcs)
R32 SKYLINE GTR
R32 SKYLINE GTS-T
R33 SKYLINE GTR
R33 SKYLINE GTS-T
R34 SKYLINE GT-T
S13 CA18 180SX
S13 CA18 SILVIA
S13 SR20 180SX
S13 SR20 SILVIA
Purchased to install the hicas delete kit on my R33 GTST. Installation was a breeze, cleaned the knuckle with 600grit sandpaper, covered all contact surfaces with some moly grease and the brushes pushed right in with a g clamp.
After driving on these for well over 1000km now, I couldn't be happier. They have a real positive feel and haven't made a single squeek.
popped the inner piece in the freezer for a few minutes super easy to install took about 40 minutes
I had to purchase these again since the original ones that came with the v4 Toe arms were 1 piece and crumbled apart. These are better since they changed design to 2 piece.
My Driftworks bushes had dry rotted and practically fell out. These 2 piece GKTech bushes were so easy to fit I didn't have to take the knuckle off the car. Little grease on the bushes and I pushed them in by hand. Tapped the collar in with a hammer and refitted the arms. So easy to do. GKTech for the win everytime.